Fleece Performance PowerFlo Lift Pump & Fuel System Upgrade Kit – 2011-2016 6.7L Powerstroke Short Bed (FPE-PF-FMC-1116-SB)

Upgrade your 6.7L Powerstroke’s fuel system with the Fleece PowerFlo Lift Pump Kit. This complete drop-in solution replaces the factory in-tank sending unit and frame-mounted pump/filter assembly with a high-flow, dual-gerotor PowerFlo lift pump and a new filter base fitted with a Donaldson 4-micron filter.

Key Benefits

• Supports up to 800 HP with significantly increased flow capacity
• Dual ultra-quiet gerotor design for smooth, reliable operation
• Active fill bucket eliminates the need for tank sumps, draw straws, or extra filtration
• No more ¼-tank issues common with other high-flow lift pumps
• True plug-and-play installation — no cutting, splicing, or modifying factory fuel lines, tank, or wiring
• Retains factory water-in-fuel sensor and full diagnostic functionality
• Threaded -8 O-ring outlets for easy conversion to aftermarket fuel lines if desired
• Validated with S&S Diesel DCR and CP4 Disaster Prevention kits
• Compatible with up to 20% biodiesel
• CARB EO D-834-18

What’s Included

• PowerFlo in-tank lift pump with integral fuel level sender
• New frame-mounted filter base with Donaldson filter (P553203)
• Water-in-fuel sensor
• Chassis wiring harness + WIF extension harness
• Fuel tank O-ring and all necessary mounting hardware

Fitment

• 2011–2016 Ford F-250 / F-350 / F-450 Super Duty with short bed
• Direct replacement for OE part numbers BC3Z-9275-A and BC3Z-9A299-A
• Confirmed fitment with Titan and S&B aftermarket tanks

Operating pressure is approximately 65–70 psi at idle. Estimated install time is around 2 hours with basic hand tools.

Pair this kit with the Fleece under-hood filter assembly (FPE-FMC-UHFA-1123) and optional fuel heater for the ultimate 6.7 Powerstroke fuel system setup.

Backed by Fleece Performance’s lifetime limited parts warranty.