Replace the rubber cab mounts on a 2008-2016 Ford F-250 or F-350 Super Duty before the cab shifts on the frame and the doors go out of line. Factory rubber cracks and crushes, so the body sits low and the bed no longer matches the cab. Daystar KF04060BK replaces those mounts with polyurethane, new steel shells, and new bolts. You are not pressing new bushings into the crushed cups.

• Polyurethane mounts: The new mounts are a different size than the crushed rubber, and they hold the cab at the original factory height instead of packing down.
• Part number: Daystar KF04060BK fits 2008-2016 Ford F-250 and F-350 Super Duty trucks, 2WD and 4WD.
• Color: The kit may arrive black or gray. Either color is the same mount kit.
• Cabs covered: Regular cab, Super Cab, and crew cab pieces are in the box, and not every piece is used on every cab.
• In the kit: Eight M04060-01 mounts, eight M04060-02 mounts, two smaller M03306 mounts, eight S22545 small steel mounts, eight S22319 large steel mounts, two S10126 washers, and hardware kit BP04057.
• Bolt lengths: Use six M12 x 1.75 x 130 mm bolts, two M12 x 1.75 x 200 mm bolts, and eight M12 washers. If a bolt does not match the hole, reuse the factory bolt.
• Position 3: Some trucks need the smaller M03306 mount at position 3 instead of M04060-02. If the lower M04060-01 mount will not seat in the frame, reuse the original lower mount.
• Torque: Tighten the bolts in a cross pattern until the steel shells seat, about 45-55 ft-lbs, then retorque them after 500 miles.
• Bushings only: If the steel shells and bolts are still good, Daystar KF04050BK is the bushing set without hardware.
• Does not fit: A 1999-2007 Super Duty, which uses Daystar KF04058BK, or a 2000-2005 Ford Excursion, which uses Daystar KF04051BK.
• Not in the box: Mounts for the bed. This kit is the cab, including the radiator support.

Order today to secure your replacement. Confirm the truck is a 2008-2016 F-250 or F-350, and plan to reuse any factory bolt this length does not match.