MPD S300 Single Turbo Install Kit for 2008-2010 6.4L Powerstroke (MPD-64-PSD-S300INSTALL)

Upgrade your 2008–2010 Ford 6.4L Powerstroke by converting the factory sequential twin-turbo setup to a single S300-frame turbo with the MPD (Maryland Performance Diesel) Single Turbo Install Kit. This complete install system delivers increased horsepower, significantly lower EGTs, reduced drive pressure, and more reliable power compared to the problematic stock compounds.

Key Benefits

• Dramatically lowers exhaust gas temperatures (EGTs) and drive pressure for better efficiency and engine longevity
• Increased horsepower potential with a properly sized S300 turbo
• Cleaner, simpler single-turbo layout that is easier to service and tune
• High-quality components designed for a precise fit on 2008–2010 6.4L Powerstroke engines

What’s Included

• Billet pedestal + pedestal install kit
• Oil feed and drain lines
• Mandrel-bent charge pipe
• 2-piece downpipe
• Intercooler boots and clamps

Turbo is not included — this kit is designed for use with an S300-frame turbo of your choice.

Important Notes

• Custom tuning (non-VGT / single-turbo tune) is required for proper operation and performance.
• Manufacturer instructions are limited; professional installation or direct manufacturer support is recommended.
• Fits 2008–2010 Ford 6.4L Powerstroke (Super Duty trucks).

This is a high-quality, complete hardware kit that gives you everything needed (except the turbo itself) for a clean single-turbo conversion on the 6.4 Powerstroke.